Option A

Set up near water supply

Position the Aquaplenish Water Changer in a convenient wet area in the apartment/house. Simply transfer the water directly to the aquarium after conditioning

Option B

Set up near aquarium

Position the Aquaplenish Water Changer next to the aquarium. Hose and connections are provided to allow the transfer of domestic supply water to the Aquaplenish Water Changer.

Instructions Overview

  1. Attach the container intake hose with the foot valve situated on the other end to the base of the Aquaplenish Water Changer. Place the Valve with the end facing upwards in its resting slot on the side of the Aquaplenish Water Changer (as shown).
  2. Sit the Aquaplenish Water Changer on the inside rim of a separate fish safe container selected to suit your needs.
  3. Attach the hose from the faucet/tap to the water intake connection on the top of the Aquaplenish Water Changer.
  4. Fill the container with water to the level required on the Aquaplenish Water Changer. Check the temperature on the electronic display as the water flows through the Aquaplenish Water Changer.
  1. Add warm water as required or attach a suitable aquarium heater to the bracket on the side of the Aquaplenish Water Changer to achieve the correct water temperature to match the aquarium.
  2. Test the water and add the chemical additives as required.
  3. Press the recirculate button to thoroughly mix the and disburse the chemicals. Note: The recirculation and aeration process over time may naturally reduce chlorates found in some domestic water.
  1. Connect the hose to the Fill outlet on the top of the Aquaplenish Water Changer. Attach the end of the hose to the aquarium hose bracket/hook and place on the rim of the aquarium with the outlet pointing down in the aquarium.
  2. Gently depress with your finger the button facing upward on the end of the submerged foot valve as it is positioned in its slot on the Aquaplenish Water Changer. This allows the air in the hose to be released as the hose fills with water and primes the pump. Once the hose is full of water, release the foot valve button and remove from its slot allowing the hose to drop to the floor of the container.
  3. Press the fill button on the electronic panel. Adjust the water flow speed if appropriate.
  4. When the water has been transferred to the aquarium press the off button on the electronic panel.

Shop Aquaplenish now

Buy now